A small water leak may cause a lot of damage to your property, and it often stays undetected till it’s too late, at which point it’s too late, and you’ll have to pay for costly fixings. Ceilings, carpets, and walls can be expensive to restore. You’d be surprised to know that even minor repairs can cost thousands of dollars.
Things to Check to Prevent Water Damage
As a homeowner, you should always know how to keep your property safe from water damage. We’ll show you how to prevent water damage in a few simple steps:
1. Check your toilets.
Look for any water that shouldn’t exist on the floor. Take off the tank’s top and ensure that the float is adjusted to the correct level (typically indicated by the letters WL on the inside). So it is not overflowing into the overflow pipe. Usually, all it takes is a small adjustment. Leak detection and repair can save you a lot of time and money. In case you discover toilet leaks, click this link to seek help from professionals.
2. Check your plumbing system.
Check your plumbing, especially your water pipes, both inside and outside your home. Check the area around your sinks, basins, and cupboards. Check under your sink for puddles or leaks from your pipes; also, plug your sinks and fill them up, then remove the plug and check for leaks below. If there is any water under, find the source of the leak; it could be a simple dripping faucet or a leaking waste that is easily repaired.
3. Check your hot water cylinder.
Look for leaks, wet patches on the floor, or even tiny jets of water as you inspect the valve work. Also, make sure the water isn’t pouring out of the air vent on low-pressure open vented hot water cylinders.
4. Water valves.
Above all, make sure you and your family know where to switch off the water in an emergency. Knowing where your water shutoff valve is located might save you thousands of dollars in the long run. There will usually be a shutoff valve in the front of your property (usually on the Council verge) with a blue lid to identify it if you have reticulated water (community supply). Furthermore, a water pump and the water storage tank shutoff valve should be switched off on the house with a non-reticulated water supply (your water comes from tanks).
5. Check your roofing.
Check your roof and spout outside of your home for any problems. Constantly clear out all fallen leaves from your spouting, as blocked spouting, particularly inner gutters, can cause significant water damage to your ceilings. Furthermore, check roof penetrations such as chimneys and flues, particularly flashings.
Loose nails or screws, damaged flashings, or perhaps gaps under flashings are all signs of roof problems. Look for wet patches on your ceiling too. Roof leaks, even little ones, can quickly cause serious ceiling and structural damage. Tek screws can replace loose nails, and Plumbers Roofing Silicone can be used to reseal flashings. You can check out Naples restoration services to learn more about water damage.
Conclusion
You have to keep in mind that it is better to be safe than sorry. If you notice any sign of a water leak anywhere, despite how small it appears to be, have it fixed immediately or fix it yourself. You may put it off and forget about it, and then the small leak turns into a large flood when you’re off shopping or on vacation.
